Installing a Brick Paver Walkway or Brick Block Concrete

The usage of Bricks or Pavers to create a pathway or patio area complements a home in a way that is unmatched. In addition, installing a Brick or Paver pathway does not always need a pro.

The secret to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be set up. In addition, string lines must be strung on each side of the pathway.
When the area has been dug down, 3/4" gravel stone need to be laid in and tamped down securely. 2" of sand, or stone dust need to be spread out over the gravel. Again the sand/stone dust should be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline ought to equal the density of the brick or paver.

Now that you have a steady base, put a 1" pipeline or ledger board the length of the walkway on either side of the pathway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will serve as your sidewalk border and assistance to maintain the stability and shape of the walkway. You can get these plastic strip borders at many home enhancement shops. The strips ought to be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

You can then start to lay the bricks/pavers as soon as this is done. There are numerous patterns you can lay. I particularly like the Herring Bone pattern. The key to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again assist preserve the integrity of the sidewalk.

Inevitably bricks/pavers will need to be cut or divided when developing the walkway. To in fact cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you desire to break the brick. If your walkway has curves you will need to buy/rent a wetsaw.

After setting up the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and pack down firmly.
Spread stone dust over the brand-new pathway and sweep into read more the cracks. This will finish the interlocking of the bricks and help to remove any weed growth.


In addition, setting up a Brick or Paver walkway does not necessarily require a pro. The secret to setting up a Brick or Paver Walkway is read more to first appropriately prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, put a 1" pipeline or journal board the length of the walkway on either side of the pathway. These strips will act as your sidewalk border and aid to keep the stability and shape of the walkway. Undoubtedly bricks/pavers will need to be cut or split when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *